The Tumble Chiller is designed to chill filled
hot casings from +85°C to + 4°C in less than approximately
one hour until their temperature has been reduced.
 |
Chiller is designed to accept loads of
up to approximately 750 litres (TC-75), 1000 litres (TC-100)
of product at a time. |
|
Drum is designed to gently rotate. The
operator will choose the mode of operation according to the
nature of the product. |
|
Chiller is equipped with a heat exchanger
to seperate the externally supplied cooling medium from the
product chilling water. |
|
Chiller is designed to reduce the temperature
of the hot product from +85°C to +4°C in less than approximately
one hour, dependent on product's ability to give up heat. |
|
It is fully self contained, piped and wired,
and requires only the connection of the operating services. |
|
Adjustable feet for levelling and cleaning
under machine. |
|
Manufactured totally in 304 polished stainless
steel. |
|
Stainless steel plate heat exchanger. |
|
Air system and pressure gauge, as standard. |
|
Variable water level switching. |
|
Lift off side panels for easy access and
maintenance. |
|
Manual over-ride system, on drain and door
opening. |
|
All electrical components mounted in sealed
enclosed cabinet tropicalised prior to despatch. |
|
Digital temperature readout programmable
to achieve any cleaning or re-thermalizing requirements. |
|
Fully interlocked door, (diameter size
880mm). |
|
Simple controls for either cleaning or
cooling operations. |
|
Selecting cooling cycle and time with added
safety should desired temperature not be reached the microprocessor
counts an additional 5 minutes and re-checks. |
|
The door is totally interlocked until the
set parameters are achieved. |
|
PLC controlled for simplicity and reliability. |
|
All valves pneumatically piston operated
for reliability. |
|
In line filter for protection against burst
bag. |
